Snake Wrapped Skull Ring – 925 Sterling Silver

Distinguish the 33g portrait from lighter snake rings

• Material: International standard 925 sterling silver, as listed
• Published weight: 33g
• Listed face reference: 28 x 20 mm; axes are not separately defined
• Live sizes: US 5 through 15, including half sizes
• Visible form: Single textured snake over a long-bearded skull

Measure the intended finger and inspect the side view for beard and snake projection. Confirm the exact variation before checkout.

A 33g face can rotate when loose, while the beard may contact an adjacent finger. A stable fit should still pass the knuckle without pain.

Choose it for the combined serpent, crown and beard, not as a generic two-snake or rattlesnake ring.

The serpent crosses the crown rather than forming the band

Verified views show one scaled body running above the skull and curving along its side. Beneath it, a full beard extends below the jaw while deep eye sockets and teeth remain visible.

The page does not establish a cobra hood, rattlesnake species, mythological identity, protective effect or venom symbolism. Snake and beard describe only visible form.

This SKU owns a serpent-wrapped bearded skull. Product 5263 has a side-facing skull in a rattlesnake composition; product 5251 has two snakes and no skull.

Brush scales and beard in separate directions

Remove the ring for tight gloves, lifting and machinery because the snake ridge and beard can catch or press against the hand.

Use a soft brush along the snake scales, then follow the beard grooves downward. Dry under the coiled body and beneath the jaw.

GIA supports direct ring measurement; CCI warns that heavy polishing can soften scale and beard relief.

Store the ring face-up so the snake ridge and beard do not press into another object.

Inspect the highest-contact surfaces and every fastening point under good light before wear. Stop using the piece if any part becomes bent, loose, cracked or uncomfortable.

Snake identity, beard relief and fit questions