Skull Mask Ring – 925 Silver Gothic Mask Ring

Flush the grille channels and layered cheek recesses

Remove the ring for lifting, machinery, sports or impact work. Inspect the long lower edge and side ridges after any snag or hard contact.

Use soft bristles along each vertical rib, beneath the brow and between side layers. Rinse and dry the deep channels; avoid sharp picks and heavy polishing.

GIA supports exact fixed-size selection, FTC supports only the published 925 identity, and CCI recommends restrained cleaning to preserve silver relief.

Keep the mask upright in a separate padded compartment so the grille and cheek ridges cannot be pressed by other pieces.

A vertical mouth grille extends beneath the armored brow

The lower face is not a conventional tooth row. Parallel vertical ribs run from beneath the nose to the bottom edge, making the mask appear longer and more mechanical. Curved ridges frame both cheeks, while the crown stays smoother and more helmet-like. The interior skull relief is visible only from the rear and does not replace the front identity.

Armored and grille describe sculpted appearance, not protective equipment, a breathing device, a named warrior, cultural mask or licensed character. No removable faceplate, filter, hinge or moving mouth is documented.

Product 9258 uses a fully covered segmented face with narrow eye panels. This design retains skull sockets and an armored brow above a distinctive vertical mouth grille.

Account for 38 g and the long lower-mask profile

• Material: 925 silver, as listed
• Listed size: 35 × 25 mm; axes are not defined
• Published weight: 38 g
• Ring sizes: US 7–14, including half sizes
• Visible construction: armored brow, skull sockets and vertical ribbed mouth grille

Choose the exact fixed size. The lower grille extends farther down the finger than a short-jaw skull, while side panels widen the top. Check knuckle and neighboring-finger clearance from the side view.

Measure the intended finger and knuckle. The listing does not label the 35 × 25 mm axes, and no size-level mapping is supplied for the 38 g reference.

Choose this design for the vertical ribbed mouth; compare segmented full-face, respirator or classic tooth-row designs for those different constructions.

Mouth grille, mask identity and interior-detail questions